![]() Shift and right click the elevator control block on the floor you want it set to (quick tip: place the control block one block above where you’re wanting the elevator to stop at). You can also put in multiple blocks to see more of the numbers at a time. Give the block a right click to bring up the button interface, and simply right click to bring up more numbers. To tell the elevator where each of your floors are, place a control block down. ![]() To do this, hold shift and right click, then you’re ready to go. To begin using the elevator in the Elevators Mod by Thutmose, you need to put it into elevator set mode. To make the elevator bigger by more than one block, toggle the numbers around the center block and it will create however many green dots (and blocks) you’re wanting. To break it or kill the elevator, hold shift and click with a stick. ![]() ![]() Each green dot you see is equal to one single elevator block. This will create the lift block you need. Once that is completed, you’ll need an elevator block, a controller block for every floor you’re wanting the elevator to stop at (no more than 64), and the device linker or mod wrench. Start first by building an elevator shaft in your house. How do you build an elevator in your Minecraft world? This is a tutorial to teach you how. Are you sick of running up and down stairs repeatedly in your Minecraft world? One word can fix your problems: the Elevators Mod by Thutmose for Minecraft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |